Vascular berrys

Well I have been doing Processing sketches up until now some samples below (these all grow etc) I was going to 3D-ify them into solids, but that will take me too long, for too little output. (I'll post up those tomorrow)

I did however have an idea for some 3d print models: Basically berrylike things growing from stalks from ones veins. the berrys are like a cage filled with a jellylike substance :)

So Idea had, I set to learning houdini to achieve it :)

What you see here is just the jellyless shells attached to stalks:

And a single berry shell:

so ya those are screenshots of my WIP, my idea is to get these 3D printed then dye them, lacquer them then set the pods into jelly so they get filled with... well Jelly.

The berrys themselves have no back so they would sit against the skin and "stick" there and can be peeled off.

The models aren't quite done but I hope to have them mostly finished by tomorrow.

Chur